Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 5
Vision 1 manual page 6
Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_6.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 6
SECTION ONE
ASSEMBLY (CONT'D.)
Locate the plug-in modules for you aimer. Check each module for damage prior to inserting into
module ports at rear of aimer housing. There are three (3) module ports.
IMPORTANT! - POWER MUST BE OFF WHEN INSERTING MODULES!
Insert aiming module into port two (2). Insert module port cover(s) in remaining port(s). Insert the
power cord provided with the unit into the power inlet on the side (FIG. 2, C) of the aimer housing.
Insert the male end of the power cord into a "grounded" receptacle which has 110-120 VAC power
(U.S. and Canada only).
If your aimer has the printer option, install the printer on the aimer carriage cross piece on the back of
the aimer (FIG. 3, A). Install the printer module (FIG. 3, B) and printer cords (FIG. 3, C). Printer
module must be inserted into module port number 1.
Insert the printer power supply provided into the power receptacle located next to the aimer On/Off
switch (FIG. 3, D).
The optional printer is powered by the aimer control switch. To activate, press the "SEL" button on
printer. A lighted "on-line" light located on printer will verify that printer is operational (FIG. 3, E).
See instructions for printer included with printer.
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]