Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 39
Vision 1 manual page 41
Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_9.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 41
SECTION SIX
6.1 EQUIPMENT MAINTENANCE
The Vision 1™ Image Processing Headlamp Aimer has been designed to provide a lifetime of
carefree performance. Maintenance is limited to occasional lubrication with a light machine oil of the
base casters and the vertical tubes. The aimer housing lens should periodically be cleaned with an
anti-static video screen cleaner, taking care not to allow any abrasive substance to come in contact
with the lens.
DO NOT ALLOW ANY SOLVENTS TO COME IN CONTACT WITH THE AIMER LENS. DO NOT
ALLOW ANY CONTACT BY WATER OR OTHER LIQUIDS TO THE AIMER OR MONITOR
HOUSING.
THERE ARE NO USER SERVICEABLE COMPONENTS WITHIN THE AIMER HOUSING OR
MONITOR ASSEMBLY. REFER ANY NEEDED REPAIRS OF THESE COMPONENTS TO
QUALIFIED FACTORY SERVICE PERSONNEL ONLY.
6.2 EQUIPMENT OPTICAL CALIBRATION
The Vision 1™ Aimer has been calibrated at the factory and requires no further calibration at your site. The unit is designed so that once the
factory calibration has been performed the unit cannot become "un-calibrated" unless the unit has sustained physical damage. The calibration is
checked as part of the power-up self test to assure no problems are evident. If upon checking the calibration, the unit finds a malfunction, it will
display "CALIBRATION CHECK FAILURE." If this happens, contact a HOPPY® Customer Service Representative at 1-800-390-7904 for
corrective action.
6.3 EQUIPMENT SPECIFICATIONS
Vision 1:
Image Processing Aimer
Order #82001
With United States Aiming
Module and Floor Track
Printer:
Printer with Module
Order #82060
With Twin Head Serial Dot
Impact with Cartridge Ribbon
RS-232-C Interface
2.25" Paper Width
ELECTRICAL:
Voltage Input:
84-260 VA
Freg. Input:
50-60 H
Input Fuse:
1.5 Amp-250 VA
Power:
50 Watts @ 120 VAC
MECHANICAL:
Height:
63 Inches
Size (Base):
24.25 Inches X 22 Inches
Size (Aimer Head):
22 Inches X 16 Inches
Weight:
145 Pounds
Shipping Wt:
200 Pounds
Cubic Space
35 Cubic Feet
Track:
3 Sections (4 Feet Each)
AMBIENT:
Operating Temp:
30-105 Degrees Fahrenheit
Storage Temp:
0-120 Degrees Fahrenheit
Humidity:
0-95% (non-condensing)
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]