American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 36)

Vision 1 manual page 37 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_37.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 37
SECTION FIVE
5.5 TRACK ALIGNMENT - "EXPERT MODE ON"
From the Main Menu (FIG. 1), press the "ALIGN HEADLAMPS" button, (Button 2). The aimer will
display (FIG. 2):
SET BAY NUMBER
INCREASE VALUE
DECREASE VALUE
ENTER CURRENT VALUE
BAY NUMBER TO SET
1
The number displayed at the bottom of the screen (FIG. 2) is the active bay. To change to a
different aiming bay, press the "INCREASE VALUE" button, (Button 3), or the "DECREASE VALUE"
button, (Button 4), until the desired aiming bay number is displayed. When the desired aiming bay
number is displayed, press the "ENTER CURRENT VALUE" button, (Button 5), the aimer will
display (FIG. 3):
LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
This control screen allows the operator to turn on the alignment laser to use as a guide when
aligning the aimer head to the optical center of the passenger side headlamp. When the alignment
laser is energized the aimer will continue to beep, and display the message "CAUTION LASER
ACTIVE" at the bottom of the monitor screen (FIG. 3).
Press the "NEXT STEP" button, (Button 5). The alignment laser will automatically be de-energized
and the aimer will display (FIG. 4):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]