American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 4)

Vision 1 manual page 5 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_5.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 5
SECTION ONE
1.1 ASSEMBLY
Inspect the aimer carefully for any signs of external damage. If any damage is noted, contacted a HOPPY® representative for further information.
Clean and inspect the vertical tubes. Spray a light machine oil onto a clean rag to clean what dust and debris from the vertical tubes may have
accumulated during shipment.
Release the vertical brakes by gripping the carriage support handles and depressing the brake buttons. The brake buttons are located (FIG. 1,
A) on top of the right and left side of the carriage support piece that holds the aimer housing (FIG. 2, A) to verify that the vertical tubes have not
been damaged in transit. Raise the aimer housing several feet and release the brake buttons. Check for any vertical movement of the unit to
verify the proper operation of the brakes.
Locate a clear area of shop floor and roll the unit back and forth (FIG. 2, B) several times across 10 feet of floor. Observe that the unit rolls
smoothly in a straight line.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]