American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 34)

Vision 1 manual page 35 Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_22.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 35
SECTION FIVE
5.4.4 LAMP TYPE MENU
SCREEN 9:
FOG/AUX LAMPS
HIGH BEAM
LOW BEAM
NOTE: LEVEL THE AIMER
REMOVE LASER LOCATOR STICKERS
This screen (FIG. 7) allows the operator to select the type of lamp to be aimed. Make a selection
by pressing the appropriate button. Make necessary adjustments to assure aimer is level. The
aimer will then display the aiming screen (FIG. 8).
The selected lamp type is displayed across the top of the aim screen. At the upper left hand corner
the bay number is displayed. Next to the bottom of the aim screen the measurement of the aim-
point and the approximate candela (brightness) value is displayed. On the bottom line of the
monitor, the aimer displays "PASSENGER SIDE" (FIG. 8), indicating the aimer is aiming the
passenger side lamp.
Press the "PR" (PRINT) button, (Button 4). The operator can generate a printout of the current aim
information, if the printer option is installed.
Press the "OK" button, (BUTTON 5). The aiming cycle for that lamp is completed (FIG. 9), and the
aimer displays instructions to move the aimer to the driver side lamp (FIG. 10).
Press the "OK" button, (Button 5), a second time. The aimer will display (FIG. 11):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]