American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 30)

Vision 1 manual page 31 Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_18.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 31
SECTION FIVE
POSITION AIMER
SCREEN 12:
ROLL AIMER TO DRIVERS SIDE OF VEHICLE AND RAISE OR LOWER AIMER HEAD TO
POSITION LASER AT OPTICAL CENTER OF LAMP TO BE AIMED.
CHECK IF AIMER IS LEVEL.
NEXT SCREEN ACTIVATES LASER
Press the "NEXT SCREEN ACTIVATES LASER" button, (Button 5). The aimer will display (FIG.
14):
LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
AFTER CENTERING, REMOVE LASER LOCATORS
This control screen allows the operator to turn on the alignment laser to perform the tasks described
in Screen 12. When the alignment laser is energized the aimer will continue to beep, and display
the message "CAUTION LASER ACTIVE" at the bottom of the monitor screen.
Press the "NEXT STEP" button, (Button 5). The aimer will display the aiming screen (FIG. 15).
The selected lamp type is displayed across the top of the aim screen. At the upper left hand corner
the bay number is displayed. Next to the bottom of the aim screen the measurement of the aim-
point and the approximate candela (brightness) value is displayed. On the bottom line of the
monitor, the aimer displays "DRIVER SIDE" (FIG. 16), indicating the aimer is aiming the driver side
lamp.
Press the "PR" (PRINT) button, (Button 4). The operator can generate a printout of the current aim
information, if the printer option is installed.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]