American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 8)

Vision 1 manual page 9 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_9.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 9
SECTION TWO
2.2 SELECT MEASUREMENT
From the "SET OPTIONS" screen (FIG. 7), press the "SELECT MEASUREMENT IN/CM" button
(Button 1). This will allow the operator to select (FIG. 8) either inch increments, (Button 3), or
centimeter increments, (Button 4). When the desired measurement is displayed as active at
bottom of the screen (FIG. 8), press the "SAVE SETTINGS" button, (Button 5), to continue.
2.3 SETUP AIMING BAY(S)
For aiming areas, select floor surfaces that are reasonably level. Avoid extremes and variable
slopes caused by floor drains.
From "SET OPTIONS" screen, press "SETUP AIM BAY(S)", (Button 2).
This menu (FIG. 10) allows the operator to select from one to thirty areas to be designated as
aiming bays.
Enter the number of separate aiming bays to be used by pressing the "INCREASE VALUE" or
"DECREASE VALUE" button(s), (Button 3 or Button 4). When the number displayed is the number
of separate aiming areas used, press the "ENTER CURRENT VALUE" button, (Button 5), to
continue with the aimer preparation.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]