Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 35
Vision 1 manual page 36
Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_36.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 36
SECTION FIVE
LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
AFTER CENTERING, REMOVE LASER LOCATOR STICKER
This control screen (FIG. 11) allows the operator to turn on the alignment laser to use as a guide
when aligning the aimer head to the optical center of the driver side headlamp. When the
alignment laser is energized the aimer will continue to beep, and display the message "CAUTION
LASER ACTIVE" at the bottom of the monitor screen.
Press the "NEXT STEP" button, (Button 5). The aimer will display the aiming screen (FIG. 12).
The selected lamp type is displayed across the top of the aim screen. In the upper left hand corner
the bay number is displayed. At the bottom of the aim screen the measurement of the aim-point
and the approximate candela (brightness) value is displayed. On the bottom line of the monitor, the
aimer displays "DRIVER SIDE" (FIG. 12), indicating the aimer is aiming the driver side lamp.
Press the "PR" (PRINT) button, (Button 4). The operator can generate a printout of the current aim
information, if the printer option is installed.
Press the "OK" button, (Button 5). The aiming cycle for that lamp is completed (FIG. 13), and the
aimer displays "AIM COMPLETE" (FIG. 14) and then returns to the Main Menu.
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]