L.B. White Pilot - Manual (Page 27)

Air Diverters
Installation
Instructions
Depending on model number, two designs of air diverters
may be available for your heater. The air diverters allow the
hot discharge air to be blown out either in two 45 degree
paths or in one direction only (two-piece diverter kit only).
Either way promotes good air movement and circulation.
Two-PPiece AAir D Diverter
1. Install the air diverter as follows. This is a typical
procedure for all heaters. Appearance of the outlet on
heater may vary from model to model.
a. The air diverter’s notched tabs on each half will
pop into the blower outlet between the inside of
the case assembly and the blower housing outlet.
If the notched tabs do not pop into the blower
outlet, loosen (do not remove) the blower outlet
screws. Doing this provides a gap into which you
can insert the tabs.
b. The air diverter halves are installed so the notches
in the tabs are up against the formed guard of the
blower outlet.
c. Tighten blower outlet screws.
August 1999
2.11-1 1
Diverters PPointed iin O One D Direction Diverters PPointed B Both LLeft aand R Right