L.B. White Pilot - Manual (Page 34)

Cleaning Instructions
Preventative
Maintenance
4.2-1 1
1. Before cleaning, shut off all gas supply valves and
disconnect electrical supply.
2. The heater should have dirt or dust removed
periodically:
a. After each flock or between building re-population,
give the heater a general cleaning using
compressed air or a soft brush on its interior and
exterior. At this time, dust off the motor case to
prevent the motor from over-heating and shutting
the heater down.
b. At least once a year, give the heater a thorough
cleaning. At this time, remove the fan and motor
assembly and brush or blow off the fan wheel,
giving attention to the individual fan blades.
Additionally, make sure the burner air inlet venturi
ports and the throat of the casting are free of dust
accumulation and the area between the heat
chamber top and inside case is also free of dust.
c. Observe and obey all instructional warnings
pertaining to cleaning procedures located on each
heater.
August 1999
WARNING
Fire, B Burn, aand EExplosion H Hazard
■ This heater contains electrical and mechanical components in the gas management, safety and airflow systems.
■ Such components may become inoperative or fail due to dust, dirt, wear, aging, or the corrosive atmosphere of an
animal confinement building.
■ Periodic cleaning and inspection as well as proper maintenance are essential to avoid serious injury or property
damage.