Apple Motion 4 - Manual (Page 472)

• Source value outside min and max: When this item is selected, the link will apply only
when the source value stays outside of a defined range. If the source value falls above
the defined minimum, or below the defined maximum, the link behavior will stop.
When selected, the Clamp Source Values Within Range checkbox as well as offset,
minimum, and maximum sliders for each setting associated with the source parameter
will appear at the bottom of the Behaviors tab. If the source parameter has a single
slider, such as Outline Width, there will be one set of three sliders (offset, minimum
and maximum) for that setting. If the source parameter has multiple sliders, such as
Shear X-Y, there will be sets of three sliders for each of those settings.
Clamp Source Value Within Range: This checkbox becomes available when the Apply
Link pop-up menu is set to a choice requiring a minimum or maximum value. When
selected, values that exceed the defined range will be pinned to the highest or lowest
allowable setting.
(Parameter) offset: This slider allows you to create a constant offset between the source
parameter value and the value applied to the target parameter.
(Parameter) min: When the Apply Link When pop-up menu is set to “Source value above
minimum,” “Source value between min and max,” or “Source value outside min and max,”
a “min” slider appears for each component of the source parameter. Adjusting this slider
defines a minimum value to limit when the link behavior is active.
(Parameter) max: When the Apply Link When pop-up menu is set to “Source value below
maximum,” “Source value between min and max,” or “Source value outside min and max,”
a “max” slider appears for each component of the source parameter. Adjusting this slider
defines a maximum value to limit when the link behavior is active.
HUD Controls
The HUD lets you set all parameters and change the parameter source and target.
472 Chapter 9 Using Behaviors