Apple Motion 4 - Manual (Page 738)

The animation begins at the original value for any added parameter, then transforms to
the value you specify in the Sequence Replicator parameters. The animation begins at
the origin of the pattern (set in the Origin or Build Style parameter of the Replicator tab
or HUD) and moves through to the end of the pattern.
Adjusting the Sequence Control Parameters
Once you have created a sequence animation, you can use the Sequence Control
parameters to change the manner in which the sequence moves through the replicator
pattern. The following section continues with the project used in the previous examples.
To change the way the sequence moves through the pattern
1 With the Sequence Replicator behavior selected, display the Behaviors tab in the Inspector.
2 Play the project (press the Space bar) to see the effects of the sequencing.
By default, Sequencing is set to “To,” which specifies that the animation begins at the
original value of the cells and moves to the value set in the Sequence Replicator behavior
for that parameter. The starting point for the sequence animation is based on the build
or “origin” of the pattern (as defined in the Origin or Build Style parameters in the
Replicator tab). In the example project, the elements begin completely opaque, at 100%
scale, and with 0 degrees of rotation at the origin of the pattern. As the sequence moves
toward the end of the pattern, the elements become completely transparent, are scaled
to 190%, and are rotated 160 degrees.
3 In the Sequencing pop-up menu, choose From.
The animation moves from the value set in the Sequence Replicator behavior to the
original value of the cells. This is the opposite of the To Sequencing option.
4 In the Sequencing pop-up menu, choose Through.
738 Chapter 12 Using the Replicator