Assembly, Assembly -13 – JLG 450A_AJ Series II Service Manual User Manual
Page 225
Advertising
SECTION 4 - BOOM & PLATFORM
3121290
– JLG Lift –
4-13
3.
Inspect wear guide condition. Measure thickness not
less than 0.123" (3.12 mm).
Assembly
1.
Gather all components and tools to one location.
2.
Install thrust washer (16) on shaft (2) and end cap (4).
3.
Install exclusion seal (5) in groove on shaft (2) and end cap
(4) around outside edge of thrust washer (16).
Advertising