JLG 450A_AJ Series II Service Manual - Manual (Page 332)

SECTION 6 - JLG CONTROL SYSTEM
6-22 – JLG Lift – 3121290
LOAD SENSOR:
17*
* Only visible if Load
Sensor Menu selection
is not 0 and under cer-
tain market selections.
* Certain market selec-
tions will limit load sen-
sor options. 0
1
1 ON ROTATOR: Use the on-board load sensor for all models except those
which use the Leveling Platform Module.
4 UNDER PLATFORM: Use the EIM for load sensing.
1
FUNCTION CUTOUT:
18*
* Only visible under cer-
tain market selections.
* Certain market selec-
tions will limit function
cutout options or alter
default setting. 0
1
2
3
NO: No drive cutout.
BOOM CUTOUT: Boom function cutout while driving above elevation.
DRIVE CUTOUT: Drive & steer cutout above elevation.
DRIVE CUT E&T: Drive & steer cutout above elevation and tilted.
0
GROUND ALARM:
19*
* Certain market selec-
tions will alter default
setting. 0
1
2
3
NO: No ground alarm installed.
DRIVE: Travel alarm sounds when the drive function is active (Option).
DESCENT: Descent alarm sounds when lift down is active (Option).
MOTION: Motion alarm sounds when any function is active (Option).
3
DRIVE:
20*
* Only visible under cer-
tain model selections. 0
1
2
4WD: Four wheel drive.
2WD: Two wheel drive.
2WD W/2-SPEED: Two wheel drive with 2-speed valve.
0
DISPLAY UNITS:
21*
* Certain market selec-
tions will alter default
setting. 0
1
IMPERIAL: Deg F, PSI, LBS.
METRIC: DEG C, KPA, KGS.
0
Table 6-3. Machine Configuration Programming Information Software Version P6.1 to Present
Configuration Label/
Digit
Numb
er
Description
Default
Number