JLG 450A_AJ Series II Service Manual - Manual (Page 55)

SECTION 3 - CHASSIS & TURNTABLE
3121290 – JLG Lift – 3-15
3. Place thrust washer (11) around spindle (1A) so it rests
on bottom of internal gear (2).
4. Stand input shaft (7A) on splined end. Place one spacer
(7D) on smooth end of input shaft (7A).
5. Place spring (7C) on smooth end of input shaft (7A).
6. Place other spacer (7D) on smooth end of input shaft
(7A).
UNCONTROLLED OBJECTS CAN CAUSE EYE DAMAGE OR SERIOUS INJURY.
ALWAYS WEAR EYE PROTECTION.
7. Using retaining ring pliers, insert retaining ring (7B) in
groove on input shaft (7A) by compressing spring and
spacers together.
8. With large splined end down, place input shaft sub-
assembly (7) into spindle (1A).