Replace moving end brackets, Replace moving end brackets -27 – JLG 450A_AJ Series II Service Manual User Manual
Page 239
Advertising
SECTION 4 - BOOM & PLATFORM
3121290
– JLG Lift –
4-27
2.
Parts used: Bracket Center Pin and Center Pin Snap Ring.
3.
Take new bracket and install bracket center pin and
snap ring. Repeat on other bracket if replacing it.
NOTE: When installing snap rings make sure they are seated in
pin groove and closed properly.
Replace Moving End Brackets
REPOSITION CABLES/HOSES AND KEEP COVERED DURING GRINDING TO PRE-
VENT DAMAGE.
1.
Remove existing pins and center rivet. Remove rivet as
shown in link removal instructions on page 4-20. Repeat
on other bracket if replacing it.
Correct
Incorrect
Advertising