JLG 450A_AJ Series II Service Manual - Manual (Page 330)

SECTION 6 - JLG CONTROL SYSTEM
6-20 – JLG Lift – 3121290
STARTER LOCKOUT:
6 0
1
DISABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start can be attempted at any time during pre-glow.
ENABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start is NOT permitted until pre-glow is finished.
0
ENGINE SHUTDOWN:
7 0
1
DISABLED: No engine shutdown.
ENABLED: Shutdown engine when coolant temperature is greater than 110
deg. C or the oil pressure is less than 8 PSI.
1
TILT:
8*
* Certain market selec-
tions will limit tilt
options and alter
default setting.
Note: Any of the selec-
tions above will light the
tilt lamp when a tilted
condition occurs and will
sound the platform
alarm when the machine
is also above elevation.
1
2
3
4
5
5 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 5 degrees and above elevation; also reduces drive
speed to creep.
4 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 4 degrees and above elevation; also reduces drive
speed to creep.
3 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 3 degrees and above elevation; also reduces drive
speed to creep.
4 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 4 degrees and above elevation; also disallows
tower lift up, tower telescope out, drive, main telescope out and main lift up.
3 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 3 degrees and above elevation; also disallows
tower lift up, tower telescope out, drive, main telescope out and main lift up. 1
JIB:
9*
* Only visible under cer-
tain model selections. 0
1
NO: No jib installed.
YES: Jib installed which has up and down movements only.
0
4 WHEEL STEER:
10*
* Only visible under cer-
tain model selections. 0
1
NO: No four-wheel steer installed.
YES: Four-wheel steer installed.
0
Table 6-3. Machine Configuration Programming Information Software Version P6.1 to Present
Configuration Label/
Digit
Numb
er
Description
Default
Number