JLG 450A_AJ Series II Service Manual - Manual (Page 331)

SECTION 6 - JLG CONTROL SYSTEM
3121290 – JLG Lift – 6-21
STOUCH/SKYGUARD:
11 0
1
2
3
None: No soft touch or SkyGuard system installed.
SOFT TOUCH - Soft touch only installed.
SKYGUARD - Skyguard only installed.
BOTH(CUTOUT) - Soft Touch and Skyguard installed.
0
GEN SET/WELDER:
12 0
1
NO: No generator installed.
BELT DRIVE: Belt driven setup. 0
GEN SET CUTOUT:
13*
* Only visible if Gen Set
/ Welder Menu selec-
tion is not 0. 0
1
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only. 0
H & T LIGHTS:
14 0
1
NO: No head and tail lights installed.
YES: Head and tail lights installed.
0
CABLE SWITCH:
15*
* Only visible under cer-
tain model selections.
* Certain market and
model selections will
alter the default setting. 0
1 NO: No broken cable switch installed.
YES: Broken cable switch installed. 0
LOAD SYSTEM:
16*
* Only visible under cer-
tain market selections.
* Certain market selec-
tions will limit load sys-
tem options or alter
default setting. 0
1
2
3
4
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm
beeps (5 sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS
off ), platform alarm beeps (5 sec ON, 2 sec OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out
& main lift up, platform alarm beeps (5 sec ON, 2 sec OFF). 0
Table 6-3. Machine Configuration Programming Information Software Version P6.1 to Present
Configuration Label/
Digit
Numb
er
Description
Default
Number