JLG 600SC_660SJC Service Manual - Manual (Page 143)

SECTION 6 - UNDERCARRIAGE
3120898 – JLG Lift – 6-39
1. Install seal (12) in motor housing (2). Use the correct
retaining ring pliers in order to install retaining ring
(11).
2. Install cradles (13) in motor housing (2).
3. Install pilot valve (10) on block assembly (9).
4. Position block assembly (9) on motor housing (2).
Install four bolts (8). Tighten the bolts to a torque of
9 ± 4 ft.lb. (12 ± 5 Nm).
5. Raise the temperature of bearing (7). Install bearing
(7) on shaft (6).
6. Install shaft (6) in motor housing (2).
7. Use tooling (A) to install swash plate (4) in motor
housing (2). Install piston rod (5).