JLG 600SC_660SJC Service Manual - Manual (Page 154)

SECTION 6 - UNDERCARRIAGE
6-50 – JLG Lift – 3120898
Assembly NOTE: Make sure that all of the parts of the final drive and
the travel motor are thoroughly clean and free of dirt
and debris prior to assembly. Replace all o-ring seals
that are used in the final drive with new o-ring seals.
Reassemble the final drive and the travel motor on
tooling (A).
1. Use tooling (E) to install one half of Duo-cone seal
kit (37) into spindle (30).
2. Put a mark (40) on spindle (30). The mark indicates
the position of the original balls (33). The mark is
used in Step 18.
Table 6-20. Final Drive Required Tools - Assembly
Tool Part # Description Qty.
A 1P-2420 Repair Stand 1
B 9S-7338 Crossblock 1
3H-0465 Push Puller Plate 2
154-9326 Spring Compressor Plate 1
154-9323 Spacer 2
C 5P-4758 Internal Pliers 1
D 138-7575 Link Bracket 2
E 161-4350 Duo-Cone Seal Kit 1
F 165-1670 Socket 1
165-1671 Reaction Shaft 1
132-8119 Torque Wrench 1
132-8223 110V Power Pack 1
132-8231 220V Power Pack 1
G 6V-3075 Dial Indicator 1
6V-6167 Contact Point 1
3P-1565 Indicator Collet 1
165-8958 Plastic Base for Indicator 1
H 165-3977 Punch 1
J 155-1709 Hydraulic Test Adapter 1
3J-1907 O-ring Seal 1
6V-3965 Nipple Assembly 1
6V-4143 Coupler Assembly 2
6V-3014 Hose Assembly 1
8T-0855 Pressure Gauge 1
1U-5230 Hand Pump 1
5S-2403 Fitting 1
1S-8937 Valve 1
2D-7325 Tee 1
6V-3966 Nipple Assembly 1