JLG 600SC_660SJC Service Manual - Manual (Page 84)

SECTION 4 - BOOM & PLATFORM
4-44 – JLG Lift – 3120898
40. Next push the ENTER key, this will show you the
RESUME HYSTERESIS setting on the display, the
default setting will blink letting you know that you
can adjust.
41. Next push the ENTER key, this will show the SENSI-
TIVITY settings on the display, the default settings
will blink letting you know you can adjust.
42. Next push the ENTER key this will bring you back to
the TACHOMETER mode with the new settings if
you chose to change them.
43. Next push the (+) key this will now show you the
DS1 and DS2 settings, these are digisensor inputs
that can be tested with or without the engine run-
ning.
DEFAULT SETTINGS TACHOMETER
Threshold 15% Set Point Adj. 2553 (RPM)
Max Out 48% Load Shed 3.0 seconds
Ramp Up 0.5 seconds Load Resume Ramp 5.0 seconds
Ramp Down 0.5 seconds Shed Hysteresis 2553 (RPM)
Low Range 70% Resume Hysteresis 2553 (RPM)
DS1 & DS2 128% Sensitivity 2553 (RPM)