AirLive SNMP-FSH2602MG v2 - Manual (Page 15)

3. Configuring the SNMP-FSH2602MG v2
AirLive SNMP-FSH2602MG v2 User’s Manual 10
The SNMP-FSH2602MG v2 offers many different types of management interface. You
can configure through standard web browser (http), console (terminal), telnet, and SNMP
management. In this chapter, we will explain SNMP-FSH2602MG v2’s available
management interfaces and how to get into them. Then, we will provide the introduction
on Web Management and recommended initial settings. For detail explanations on Web
Management functions, please go to Chapter 4. For Console interface, please go to
Chapter 5.
3.1 Important Information
The following information will help you to get start quickly. However, we recommend you
to read through the entire manual before you start. Please note the username and
password are case sensitive.
‰ The default IP address is 192.168.10.1
‰ The default Subnet Mask is 255.255.255.0
‰ The default Gateway is 192.168.10.254
‰ The default username is airlive
‰ The default password is airlive
3.2 Prepare your PC
The SNMP-FSH2602MG v2 can be managed remotely by a PC through RJ-45 cable. The
default IP address of the SNMP-FSH2602MG v2 is 192.168.10.1 with a subnet mask of
255.255.255.0. This means the IP address of the PC should be in the range of
192.168.10.2 to 192.168.10.254.
To prepare your PC for management with the SNMP-FSH2602MG v2, please do the
following:
1. Connect your PC directly to the copper port of SNMP-FSH2602MG v2
3
3.
Configuring the
SNMP-FSH2602MG v2