AirLive SNMP-FSH2602MG v2 User Manual
Page 36
4. Web Management in SNMP-FSH2602MG v2
31
AirLive SNMP-FSH2602MG v2 User’s Manual
4.4.5.3 State Activity
When setup the LACP aggregator, you can configure port state activity. You can mark or
un-mark the port. When you mark the port and click “Apply” button, the port state activity
will change to Active. Opposite is Passive.
1. Active: The port automatically sends LACP protocol packets.
2. Passive: The port does not automatically send LACP protocol packets, and responds
only if it receives LACP protocol packets from the opposite device.
Note:
A link having either two active LACP ports or one active port can perform dynamic
LACP trunking.
A link having two passive LACP ports will not perform dynamic LACP trunking
because both ports are waiting for LACP protocol packet from the opposite device.
If you are active LACP’s actor, when you are selecting trunking port, the active
status will be created automatically.