AirLive SNMP-FSH2602MG v2 - Manual (Page 61)

4. Web Management in SNMP-FSH2602MG v2
AirLive SNMP-FSH2602MG v2 User’s Manual 56
4.8 System Reboot
Reboot the Switch in software reset. Click “Apply” button to reboot the switch.
4.9 Panel List
Display the Switch panel GUI. When the Switch is in stacking status, it displays the slaves
panel GUI. When the Switch is stand-alone status, it displays itself panel GUI. You can click
the port on the panel GUI to check port current information.
4.10 IP Stacking
This function allows Switch to stack up to 8 stackable switches as a unit group. When
configuring the stacking function, beware the following points.
„
Any port on the switch can be used to stack.
„ Before configuring the stacking function, make sure all stack switches are in the same
network.
„ When configure stacking function, please must configure the master switch first.
„ After stacking group has set up, all slave switches are configured through master
switch. You still can directly access to slave switch, but all functions are read and view
only.
„ To remove the switch from stacking group, you must remove the salve switch first.
When all slave switches are removed, and then you can remove the master switch
from stacking group. If you remove the master switch before slave switch, go to slave
switches one by one and use console configuration to re-configure the switch