AirLive SNMP-FSH2602MG v2 - Manual (Page 34)

4. Web Management in SNMP-FSH2602MG v2
29
AirLive SNMP-FSH2602MG v2 User’s Manual
a device on the network. LACP operation requires full-duplex mode, please refers to
IEEE 802.3ad for more detail information.
4.4.5.1 Aggregator setting
1. System Priority: A value used to identify the active LACP. The switch with the lowest
value has the highest priority and is selected as the active LACP.
2. Group ID: There are seven trunk groups for users to configure. Choose the "Group
ID" and click “Select” button.
3. LACP: If enabled, the group is LACP static trunk group. If disabled, the group is local
static trunk group. All ports support LACP dynamic trunking group. If connecting to the
device that also supports LACP, the LACP dynamic trunking group will be created
automatically.
4. Work ports: Max four ports can be aggregated at the same time. If it is LACP static
trunk group, the exceed ports are standby and able to aggregate if work ports fail. If it is
local static trunk group, the number must be as same as the group member ports.
5. Select the ports to join the trunk group. Max four ports can be aggregated at the same
time. Select the port and click “Add” button to add the port. To remove ports, just select
the port and click “Remove” button.
6. If LACP is enabled, you can configure LACP Active/Passive status in each port on
State Activity page.
7. Click “Apply” button to apply your Trunking configuration.
8. You also can use “Delete” button to delete Trunk group. Just select the Group ID and
click “Delete” button to apply your delete action.