AirLive SNMP-FSH2602MG v2 - Manual (Page 92)

5. Console Management in SNMP-FSH2602MG v2
87
AirLive SNMP-FSH2602MG v2 User’s Manual
4. Hello Time: The time that controls switch sends out the BPDU packet to check STP
current status. The valid value is 1 ~ 10 seconds. The default is 2 seconds.
5. Forward Delay Time: forward delay time. The valid value is 4 ~ 30 seconds. The
default is 15 seconds.
6. Select <Save>.
„
Per Port Setting
1. Select
<Edit>.
2. Path Cost: specifies the path cost of the port that switch uses to determine which port
are the forwarding ports. The value range is from 1 to 65535. The default is 20000.
3. Priority: It means port priority; you can make it more or less likely to become the root
port. The valid value is from 0 to 255. The lowest value has higher priority. The default
is 128.
„ Admin P2P: There are three parameters, Auto, True and False, used to configure the
type of the point-to-point link. If configuring this parameter to be Auto, it means RSTP
will use the duplex mode resulted from the auto-negotiation. In today’s switched
networks, most links are running in full-duplex mode. For sure, the result may be
half-duplex, in this case, the port will not fast transit to Forwarding state. If it is set as
True, the port is treated as point-to-point link by RSTP and unconditionally transited to
Forwarding state. If it is set as False, fast transition to Forwarding state will not happen
on this port. The default is Auto.
„ Admin Edge: If user selects “True”, this port will be an edge port. An Edge Port is a port