AirLive SNMP-FSH2602MG v2 - Manual (Page 33)

4. Web Management in SNMP-FSH2602MG v2
AirLive SNMP-FSH2602MG v2 User’s Manual 28
1Mbps, ingress rate is 500Kbps. The switch will perform flow control or Back Pressure
to confine the ingress rate to meet the specified rate.
„
In: fill in the port effective ingress rate. The valid range is 0 ~ 999. The unit is 100K.
“0” means disable rate control. “1 ~ 999” means valid rate value.
„ Out: fill in the port effective egress rate. The valid range is 0~999. The unit is 100K.
“0” means disable rate control. “1 ~ 999” means valid rate value.
9. Priority: This static priority is based on port, if you set the port as high priority,
incoming frames from this port always are high priority frame.
10. Security: When the port is in security mode, the port will be “locked” without
permission of address learning. Only the incoming packets with static MAC addresses
already existing in the address table can be forwarded normally. User can disable the
port from learning any new MAC addresses, and then use the Static MAC addresses
(introduce in below pages) function to define a list of MAC addresses that can use the
secure port.
11. Click “Apply” button to apply all configuration.
12. When you select the port, you can see port’s current configuration value which shows
in below column.
4.4.5 Trunking
Link Aggregation Control Protocol (LACP) provides a standardized means for exchanging
information between Partner Systems on a link to allow their Link Aggregation Control
instances to reach agreement on the identity of the Link Aggregation Group to which the
link belongs, move the link to that Link Aggregation Group, and enable its transmission and
reception functions in an orderly manner. Link aggregation lets you group up to eight
consecutive ports into a single dedicated connection. This feature can expand bandwidth to
Click port number to
view its port status