INFICON Sensistor ILS500F Leak Detection System - Manual (Page 86)

Declaration of Conformity 86
ninp69e1-a (1410)
14 Declaration of Conformity
INFICON AB
Box 76, SE-581 02 Linköping, Sweden
Phone: +46 (0) 13 35 59 00 Fax: +46 (0) 13 35 59 01
www.inficon.com E-mail: [email protected]
Declaration of CE Conformity
Manufacturer
INFICON AB
Westmansgatan 49
SE-582 16 Linköping
Sweden
Object of the declaration (marketing identification):
Sensistor ILS500, Leak Detection System, …
Sensistor ILS500 HP, Leak Detection System, high pressure model…
Sensistor ILS500 F, Leak Detection Filler, …
Sensistor ILS500 FHP, Leak Detection Filler, high pressure model…
Type no for construction identification: ILS.210.306
The object of the declaration described above is in conformity with the relevant Community
Directives, namely:
CE Marking Directive
(93/68/EC)
EMC Directive ( 2004/108/EC )
LVD, Low Voltage Directive (2006/95/EC)
RoHS Directive
(2011/65/EC)
Harmonized European standards which have been applied
No. Issue Subject
EN 61326-1:2006, 2 Class B: Electrical equipment for measurement, control and laboratory use.*
EN 61326-1:2006 2 Industrial Requirements Electrical equipment for measurement, control and laboratory
use.**
*Internal voltage range is not on scope of directive. AC/DC power supply is conformant and installed correctly.
**Some deviations from standard exist. Contact manufacturer for details.
Information related to the Machinery Directive (2006/42/EC):
Sensistor ILS500 is intended (when appropriate) to be incorporated into machinery or to be assembled
with equipment to constitute machinery covered by Directive 98/37/EG, as amended;
The manufacturer declares that is not allowed to put the equipment into service until the machinery
into which it is to be incorporated or of which it is to be a component has been found and declared to
be in conformity with the provisions of Directive 2006/42/EC and with national implementing legislation,
i.e. as a whole, including the equipment referred to in this declaration.
The delivered equipment (Sensistor ILS500) is intended to be connected to an emergency stop circuit.
The enclosed plug with cable jumper is only intended for testing the equipment when not incorporated
into machinery covered by Directive 2006/42/EC. The jumper plug must therefore not be used when
such machinery is put into service.
For INFICON AB, Linköping, Sweden, November 28, 2013
_____________________
Fredrik Enquist
R&D Manager