KD Scientific Allegro Peristaltic Pump Series - Manual (Page 14)

14 K
D
S
A
lle
g
ro
P
e
ri
s
ta
lt
ic
P
u
m
p
S
y
s
te
m
U
s
e
r’s
M
a
n
u
a
l
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Product Over view
OPERATING INSTRUCTIONS
POWER CONNECTIONS
1. Plug the power supply into the pump.
2. Connect to a properly rated line cord. The Allegro
Peristaltic Pump power supply has a DC power
input connector on the rear of the unit. The operating
range for the Allegro Peristaltic Pump System series is
100 – 240 VAC, 50-60 Hz.
3. Turn on the main power switch.
!
CAUTION: Do not connect to
firewire ports on a computer.
Damage may occur to the
pump or computer.
Run / Fault LED
User Interface
Touchscreen
Protective Antiglare
Close up view of the Allegro Peristaltic Pump rear connections
(connections vary depending on model type)
Foot Switch
I/O Connector
USB Serial Input
(Type B)
RS-485 Connection
(Pump to Pump)
Main Switch
DC Power Input
*Power Source -
When powering a pump
in a chain through an RS-
485 cable, toggle switch
to RS-485. Only one
pump can be powered
from the master through
the RS-485.
Allegro Peristaltic Pump shown above