KD Scientific Allegro Peristaltic Pump Series - Manual (Page 58)

58 K
D
S
A
lle
g
ro
P
e
ri
s
ta
lt
ic
P
u
m
p
S
y
s
te
m
U
s
e
r’s
M
a
n
u
a
l
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Operating the KDS Allegro Peristaltic Pump System
LOAD
Loads a method or displays the currently loaded method.
Command format:
load
load {method name}
load qs i
Query response:
<lf>[##:]Quick Start - Infuse Only (qs i)<cr>
<lf>[##]<prompt>
or:
<lf>[##:]{method name}<cr>
<lf>[##]<prompt>
FTSWITCH
Sets or displays the footswitch setting. The footswitch
may be used in a toggle on or off mode (momentary), a
press to run mode (falling), or a release to run mode
(rising).
Command format:
ftswitch [mom|rise|fall]
Query response:
<lf>[##:]Momentary<cr>
<lf>[##]<prompt>
or:
<lf>[##:]Active high<cr>
<lf>[##]<prompt>
or:
<lf>[##:]Active low<cr>
<lf>[##]<prompt>
POLL
Sets or displays the polling mode state. In polling mode,
prompts are inhibited if they aren’t generated by a typed
command. Valid states are on or off.
Command format:
poll [on|off]
Query response:
<lf>[##:]OFF<cr>
<lf>[##]<prompt>
or:
<lf>[##:]ON<cr>
<lf>[##]<prompt>
TILT
Calibrates tilt sensor.
Command format:
tilt
Query response:
<lf>[##:]Calibrating the tilt sensor...<cr>
<lf>[##:]Tilt calibration value is #<cr>
<lf>[##]<prompt>
VER
Displays the short version string.
Command format:
ver
Query response:
<lf>[##:]Allegro 2.#.#<cr>
<lf>[##]<prompt>