KD Scientific Allegro Peristaltic Pump Series - Manual (Page 38)

38 K
D
S
A
lle
g
ro
P
e
ri
s
ta
lt
ic
P
u
m
p
S
y
s
te
m
U
s
e
r’s
M
a
n
u
a
l
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Operating the KDS Allegro Peristaltic Pump System
6. To begin creating Pump Control Profile Steps,
choose the Step Definition button to enter the Step
Definition screen.
TO CREATE A NEW USER-DEFINED PROGRAM (CONTINUED)
✐
NOTE: When adding a Step to a
Program, the Step is added after the
currently selected Step (i.e. the Step that is
highlighted in blue)
7. To add a Step to your Program, choose the Insert
Step button to access the Select Profile for Step
screen. The available options include Constant
Rate, Ramp, Stepped, Pulse and Advanced
Options.
8. Selecting the Advanced Options button will allow
you to access additional Program Step options.
The Available advanced option steps are Go To,
Delay, Repeat, Link, Stop, I/O (out) Trigger,
I/O (in) Event and I/O (out) Event Link.
9. Choose the Program Step type that you want to
add to the Program. If you choose a pumping
profile (e.g. Constant Rate, Ramp, etc.) you will be
taken to the Step Definition screen for the selected
Program.
10. Complete the parameter entry applicable to the
selected Pump Operation Profile; follow the
detailed instructions supplied in the Pump
Operation Profiles (Existing and User-Defined
Programs) section later in this Guide.
11. When you have completed all parameter entries
on the Step Definition screen or completed the
required entries for Advanced Options, choose the
button to save your changes and return to the
Program Steps Summary screen.
12. Repeat items 7-10 in this procedure to include
additional Steps in the Program.
13. When you are done adding all required Steps to
the Program, choose the Enter button to return to
the Program Main screen.