Gauge wheel arm bushing and/or seal replacement, Gauge wheel arm pivot spindle replacement, Gauge wheel arm pivot spindle replacement -22 – Kinze 3660 Lift and Rotate Planter Rev. 7/14 User Manual

Page 102

Advertising
background image

M0217-01

Model 3660

5-22

Rev. 7/11

TM

Lubrication and Maintenance

GAUGE WHEEL ARM PIVOT SPINDLE RE-
PLACEMENT

1. Remove gauge wheel and arm assemblies from

shank assembly.

2. Remove

½

" x ¾" cap screw that locks pivot

spindle in place and remove spindle.

3. Install replacement spindle and position as

shown below. Exact centering is critical.

4. Install

½

" x ¾" cap screw and torque to lock

pivot spindle in place.

5. Install gauge wheel and arm assemblies. Shim

for proper gauge wheel tire/disc blade clearance.

GAUGE WHEEL ARM bUSHING AND/OR
SEAL REPLACEMENT

NOTE: Gauge Wheel Arm bushing and Seal Driver
Kit (G1K296) is available through your Kinze
Dealer.

1. Remove gauge wheel from arm.
2. Remove gauge wheel arm from shank assembly.
3. Remove seal and bushing and discard. Clean and

dry inner bore.

4. Drive/press replacement bushing inside bore of

arm to a depth of .125" below flush.

5. Coat wiping edge of seal with grease.
6. Drive/press seal into place with lip to outside.

NOTE: Use extra care to protect the sealing lip
during installation. Apply uniform pressure to
assemble the seal into the bore of the arm. Never
apply a direct hammer blow to the seal surface.

7. Inspect gauge wheel pivot spindle.
8. Reinstall gauge wheel arm assembly and gauge
wheel.

NOTE: Use special machine bushing between
gauge wheel arm and gauge wheel.

9. Shim for proper gauge wheel tire/disc blade
clearance.
10. Lubricate with an SAE multipurpose grease.

2⅞"

Seal Seal

Bushing Bushing

Gauge wheel arm
bushings/seals

Gauge wheel
pivot spindle

Pivot spindle cap screw

Advertising