Kinze 3660 Lift and Rotate Planter Rev. 7/14 User Manual

Page 111

Advertising
background image

TM

Model 3660

M0217-01

Rev. 7/11

5-31

Lubrication and Maintenance

CENTER FRAME WEAR PADS

The 3660 planter includes a center frame section that slides up and down on a central 7" x 7" tube to move between
transport and operation positions. Part of the center frame is a slide assembly consisting of four wear pad assemblies
held in place by ¾" set screws and jam nuts, riding against a powder coated center tube.

Inspect and adjust wear pads annually to ensure planter frame is stable and planter tracks correctly. Wear pads should
lightly make full contact with center post when properly adjusted. Excessive preload on pads will cause increased
hydraulic lift pressure and may fail to lift planter when fully loaded.

ROCKSHAFT TO HITCH SHIM ADJUSTMENT

1. Install strap fixture at rockshaft cylinder location to establish 26" center-to-center cylinder mount distance.

2. Place

¼

" thick wear plate between cylinder mount bracket and lower cylinder mount. Install a shims under

wear plate using 16 and 10 gauge shims to maintain 26" distance.

Wear plate

26" strap fixture

Wear plate an shim installation

Shims

WARNING

Uncontrolled machine movement can crush or cause loss of control
resulting in death, serious injury, or damage to property and equipment.
Install all safety lockup devices before working under or transporting
this equipment.

Advertising