Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 15)

TM
Model 3660 M0217-01
Rev. 7/11 2-3
Machine Operation
1. Torque transport wheel 5∕8"- 18 lug nuts to 180 ft-lb (244 N-m).
2. Inflate tires to the following specifications:
Transport (center section) 255-70R 22.5 (“224” rim)
75 psi (517.1 kPa) recommended/75 psi (517.1 kPa) max.
Transport (center section) 255-70R 22.5" (“276” rim)
75 psi (517.1 kPa) recommended/100 psi (689.4 kPa) max.
Ground drive (wings) 7.50" x 20" 40 psi (275.7 kPa)
Liquid fertilizer piston pump 7.60" x 15" 40 psi (275.7 kPa)
Following information is general in nature to aid in preparation of tractor and planter for use, and to provide general
operating procedures. Operator experience, familiarity with the machine, and the following information should combine
for efficient planter operation and good working habits.
WARNING
Improperly operating or working on this equipment could result in
death or serious injury. Read and follow all instructions in Operator
Manual before operating or working on this equipment.
WARNING
Loose transport wheel lug bolts can result in wheel separation from
planter and cause death, serious injury, and damage to property and
equipment. Torque transport wheel 5∕8"- 18 lug bolts to 180 ft-lb (244
N-m) before operating planter for the first time and periodically after.
WARNING
Explosive separation of rim and tire can cause death or serious injury.
Overinflation, rim and tire servicing, improper use of rims and tires,
worn, or improperly maintained tires could result in a tire explosion.
WARNING
Folding or towing planter with outer transport wheel on left side
of machine removed can cause death, serious injury, or damage
to property and equipment. Tipping may occur because of narrow
wheel base. Outer transport wheel on left side of machine is shipped
removed on non-ASD planters (not bolted on) to allow narrower
width truck shipment. DO NOT REMOVE THIS ASSEMbLY AFTER
PLANTER IS ASSEMbLED FOR USE.
Tire locations
INITIAL PREPARATION
Transport
Ground drive (wing)
3. Lubricate planter and row units following instructions in Lubrication and Maintenance section of this manual.
4. Check all row unit drive chains for proper tension, alignment, and lubrication.