Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 114)

M0217-01 Model 3660
5-34 Rev. 7/11
TM
Lubrication and Maintenance
3∕16 " x 2" x 1" shim
14. Make two 3∕16" x 2" x 1" shims out of bar stock or
other suitable material.
15. Place one shim on left and one shim on right
side of center post flange. Lower planter until
center frame slide rests on them.
NOTE: When planter is lowered, no planter frame
weight is to be supported at shim stacks or landing
pad bolts – there must be space for adding shims
and adjusting bolts downward.
NOTE: Completely fill open space with appropriate combination of shims. Tolerance for filling open space is
+0.030"/-0.000".
16. Add shims to fill open space at the following locations:
• Inner hitch shim stack – left and right sides; make sure ¼" thick wear plates remain on top.
• Field stabilizer shim stack – left and right sides.
17. After adding shims, shim stack fasteners on inner hitch may be tightened. DO NOT fully tighten fasteners at field
stabilizers.
18. Raise planter on center post. Remove temporary shims from beneath center frame slide and fully lower
planter.
19. Lower landing pad bolts until they touch landing pad. Hold in place with wrench to prevent turning and tighten jam
nuts.
1. Raise planter to transport position and install safety
lockup.
2. Loosen fasteners and remove rotation stop tap
block and shims.
3. Remove safety lockup and fully lower planter.
TRIANGULATE AND SET PLANTER SqUARENESS
NOTICE
Planter frame must be square with hitch frame to ensure planter tracks correctly during operation.
Rotation stop tap block and shims