Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 113)

TM
Model 3660 M0217-01
Rev. 7/11 5-33
Lubrication and Maintenance
11. Loosen fasteners and remove one or two shims from the following locations:
• Inner hitch shim stack – left and right sides.
• Field stabilizer shim stack – left and right sides.
12. Replace fasteners at field stabilizers to keep shim stack in place.
Inner hitch shim stacks Field stabilizer shim stack
Upper set screws
8. Loosen jam nuts. Loosen and tighten set screws
until all four measurements in Step 5 - 7 are
equal.
9. Tighten all eight set screws.
NOTE: Perform Step 10 one set screw at a time.
10. Set contact pressure of upper wear pads. Loosen
set screw, then tighten to 20 ft-lb (27.1 N-m).
Hold set screw with a wrench to prevent it from
turning and tighten jam nut to 75 ft-lb (101.6 N-m).
Repeat with remaining set screws.
Some shims must be removed to preventing pre-loading of planter frame in preparation of adjusting shim stack
thicknesses.
13. Raise landing pad bolts to prepare for adjusting
shim stack thickness. Loosen jam nuts and
thread in bolts several turns.
Landing pad bolts