Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 112)

M0217-01 Model 3660
5-32 Rev. 7/11
TM
Lubrication and Maintenance
Lower front and side - six set screws Lower rear side - two set screws
NOTE: Planter must be in transport position with safety lockup installed and rock shaft cylinders fully
retracted.
1. Lock wing frames for transport, fully raise planter, and install safety lockup. Make sure top latch is around cylinder
rod and fastened with safety pin and that lower end is secured with detent pin.
CENTER FRAME RELATION TO INNER HITCH ADJUSTMENTS
2. Adjust lower wear pads. Loosen jam nuts. Loosen and tighten set screws to move center frame slide tube until
distance from outside of center tube to outside of slide tube is equal on all four sides - approximately 1½". Tighten
all eight set screws.
NOTE: Perform Step 3 one set screw at a time.
3. Set contact pressure of lower wear pads. Loosen set screw, then tighten to 20 ft-lb (27.1 N-m). Hold set screw with
a wrench to prevent it from turning and tighten jam nut to 75 ft-lb (101.6 N-m). Repeat with remaining set screws.
4. Remove safety lockup and lower planter frame until approximately 2' above top surface of outer hitch. Turn
off hydraulic power source.
Top surface of outer hitch must be parallel to bottom of center frame. Distance between them is measured at four
points:
• Top front of inner hitch to bottom of center sub-frame – left and right sides.
• Top rear of inner hitch to bottom of center frame – left and right sides.
NOTE: Subtract 8" from front measurement values before comparing to rear values.
2" x 2" x 36" tube
5. Place a 2" x 2" x 36" tube or similar straight object
on top of one leg of inner hitch, behind shim stack
as shown at right.
6. Measure at points as shown at right.
7. Repeat on other leg of inner hitch.
Measurement locations