Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 22)

M0217-01 Model 3660
2-10 Rev. 7/11
TM
Machine Operation
NOTE: Hydraulic weight transfer toolbar operates when planter is in motion and hydraulic seed rate drive is
operating.
Model 3660 planters operate using three to five dual remote (SCV) hydraulic outlets:
1. Raise and lower planter during field operation with axle rockshaft (field lift).
2. In conjuction with control console switches, controls row markers, center post, wing locks, rotation, and tongue
extension.
3. Hydraulic seed rate drive.
4. EdgeVac blower drive (optional).
5. Air Seed Delivery blower drive (optional).
Marker switch is an ON/OFF/ON type to select right or left
hand marker operation. It is disabled when a planter fold
function is selected. An indicator light illuminates when switch
is ON.
Raise/wing lock and rotate/tongue switches are MOMENTARY
ON/OFF/MOMEMENTARY ON type to select a planter fold
function. They must be held in position while operating tractor
SCV control for desired function to operate.
Down pressure switch is a MOMENTARY ON/OFF/
MOMENTARY ON type used to increase or decrease row unit
down pressure.
CONTROL CONSOLE OPERATION
Tractor’s hydraulic system and planter control console are used to raise and lower planter, rotate frame, extend and
retract tongue, lock and release wings, and operate row markers.
DANGER!
Contacting or coming close to power lines or other high energy
sources will cause death or serious injury. Keep away from power
lines or high energy sources at all times.
WARNING
being struck by a moving marker can cause death or serious injury.
Markers can move unexpectedly when SCV controls are operated.
Keep marker switch OFF when not in use.
NOTICE
Control console face is backlit with a power switch on back side.
Turn off console when not in use or tractor battery will drain.
Model 3660 control box
Work light switch is on ON/OFF type to control optional planter mounted work lights.
Point row switches are not used on Model 3660 planter. This function is controlled by Kinze Vision or Cobalt planter
controller.
A 50 amp main control box fuse and 20 amp delayed air compressor fuse are located on control box front lower left
face.