Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 81)

TM
Model 3660 M0217-01
Rev. 7/11 5-1
Lubrication and Maintenance
LUbRICATION
Following pages show locations of all lubrication points. Proper lubrication of moving parts helps ensure efficient
operation of your Kinze planter and prolongs the life of friction producing parts.
LUbRICATION SYMbOLS
Lubricate at frequency indicated
with SAE multipurpose grease. Lubricate at frequency indicated with high
quality SAE 10 weight oil or spray lubricant.
Sealed bearings are used on your Kinze planter to provide
trouble free operation.
These are located on drive shafts, row units, and transmission
bearings. Sealed bearings are lubricated for life and are not
serviceable.
SEALED bEARINGS
Sealed bearing (Typical)
AIR CLUTCH LUbRICATION
Lubricate air clutches every 75-100 hours.
Remove Phillips head screw and spray a 1-2 second burst of
silicone spray into each clutch. Reinstall screw.
Air clutch lubrication
WHEEL bEARINGS
All drive, transport, and marker hub wheel bearings should be repacked annually and checked for wear.
1. Raise wheel off ground.
2. Check for bearing endplay by moving wheel side to side.
3. Rotate wheel to check for bearing roughness. If bearings sound rough, remove hub and inspect bearings.
NOTE: To repack wheel hubs, follow procedure outlined for wheel bearing replacement in this section except
bearings and bearing cups are reused.