Leica Biosystems ASP200 S - Manual (Page 32)

32 Instructions for Use V 1.4, RevE – 03/2013
4.7 Switching the instrument on
4. Initial Operation
• After being switched on, the instrument will take
a few minutes to initialize. See opposite for cor-
responding touchscreen display ( Fig. 14 ).
• If the retort is not locked, a signal tone sounds for
approx. 10 sec. during initialization of the instrument.
It is not possible to lock the retort during this time.
• If the retort is locked, no signal tone sounds.
A signal tone sounds for approx. 10 seconds (wait-
ing time) when attempting to open the retort. The
retort cannot be opened during this time.
• After that, the FAVORITES screen will be displayed
( Fig. 15 ).
Screen saver
• A screen saver will turn off the screen display if no
key has been pressed for a (user-programmable)
time. Press any part of the touchscreen to restore
the screen.
After having been restored, the on-screen func-
tions will be nonoperational for a few seconds to
avoid accidental activation of any keys.
Fig. 15
Fig. 14
The instrument MUST be connected to a grounded power socket.
For additional electrical fuse protection, we recommend connecting the Leica ASP200 S to a
socket with a residual current circuit breaker.
• Connect the power cable to the power socket. If applicable, switch on the switch for
the power socket.
• To switch on the instrument, press in the ON/OFF switch on the rear panel of the
instrument ( Fig. 4, 42) (ON).
• Switch on the ON/STOP switch on the right of the instrument (ON).
The ON/OFF switch and the side ON/STOP switch should remain switched on at all times to
keep the heater running for the wax baths.
The ON/STOP switch can be used in emergencies to stop the instrument during while a proce-
dure is in progress.