Lenze E84DGFCA - Manual (Page 13)

Lenze · Decentralised frequency inverter 8400 motec (AS-Interface option) · EDS84DMOTASI EN 4.0 - 09/2013
13
Product description
Features and variants
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
3.2 Features and variants
The AS-Interface Communication Unit is available in the following versions:
• The AS-Interface Communication Unit is ...
• mounted on top of the Wiring Unit (E84DGVNxx);
• supplied internally by the Drive Unit (E84DGDVxxxxxxxx) and externally by the AS-i bus.
• The I/O connections can be brought into the device via M12 connectors or cable glands.
• Devices without an integrated safety system (safety option) have no analog input and no relay
output.
• The integrated safety system can be used on machines for the protection of persons.
• The Communication Unit AS-Interface supports the services of the AS-i version 3.0:
• cyclic reading and writing of single parameters
• cyclic drive control
• acyclic reading and writing of parameter sets
• acyclic query of diagnostic data
• Two AS-i slaves are contained in the Communication Unit. Thus, two AS-i addresses are
assigned.  AS-i concept of the Communication Unit ( 33)
• The acyclic communication via the AS-i bus and the slave 2 are available for the read and write
access to parameters.
• The AS-i slaves can be addressed ...
• via a programming unit or from the master or
• by means of parameters (e.g. via »Engineer«, keypad or EPM).
• Up to 31 standard slaves can be connected to an AS-i network. In this case the max. cycle time
is 5 ms. Up to 62 so-called A/B slaves can be connected if extended addressing is used. In this
case the max. cycle time is 10 ms.
• Synchronisation ( 32) of input and output data is possible.
• Communication with the Lenze »Engineer« (access to all Lenze parameters) is executed via the
diagnostic interface of the Drive Unit.
Product series Type designation Product features
Enclosure IP
65
AS-
Inte
rface
M12 I/
O
: Term
ina
l
I/
O
: M
12
Sa
fety
Inverter Drives 8400 motec
Communication Unit AS-Interface
E84DGFCAANP   
E84DGFCA9NP   
E84DGFCAAJP    
E84DGFCA9JP    

"Inverter Drives 8400 motec" hardware manual
Here you will find detailed information on the integrated safety system (safety option).
Software manual / »Engineer« online help "Inverter Drives 8400 motec"
Here you will find detailed information on how to configure the safety system (safety
option).