Lenze EMF2102IB - Manual (Page 12)

Technical data
3-4
L
_^ONMObk
Processing time in the controller (t3)
The processing time in the controller depends on the controller type and the code numbers. This is
shown in the following table:
Code numbers Processing time (2102 + controller) [ms]
Series
820X 821X/8200 vector/822X 93XX
C0046, C0135 35 1) 20 20 3)
C0050, C0150 35 20 20
C0068 70 30 30
Write other code numbers 230 20 2) 20 4)
Read other code numbers 55 20 20
1) 35 ms is valid for C0001 = 3. If C0001 = 1 and you write under C0046, access is also possible. However, the processing time is prolonged
to 70 ms.
2) For immediately following write-access procedures, the response times may be up to 50ms.
3) The code number C0046 can only be read. Use a free code number (e. g. C0141) to select a setpoint. For this, refer to the 93XX Manual.
4) This is a typical value. For some codes, the processing times may be longer. For this, refer to the 93XX Manual.
Show/Hide Bookmarks