Lenze EMF2180IB - Manual (Page 32)

6 Commissioning
6.1 Commissioning with the Lenze "System bus configurator"
32
Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Commissioning
6.1 Commissioning with the Lenze "System bus configurator"
Via the "System bus configurator", the EMF2180IB communication module is configured for
communication with the fieldbus nodes and the Lenze Engineering tools.
The "System bus configurator" is part of the following Lenze Engineering tools:
• »Engineer«
• »Drive Server«, from version 1.1 onwards
• »Drive PLC Developer Studio« (DDS), from version 2.2 onwards
• »Global Drive Control« (GDC), from version 4.7 onwards
• »Global Drive Loader« (GDL), from version 2.2 onwards

Tip!
We recommend always using the most recent version of the Lenze Engineering tools.
Current software updates for the Engineering tools and information about the system
requirements can be found in the ”Download” area at:
www.lenze.com
6.1.1 Installing/updating software

How to install or update the Lenze Engineering tools:
1. Download the corresponding file from the Download area of the Lenze homepage to your
Engineering PC.
2. Start the installation program by double-clicking the file downloaded.
3. Follow the further instructions of the installation program.
After having carried out the installation successfully, you can open the "System bus configurator"
via the MS Windows® start menu under:
All Programs  Lenze  Communication  System bus configurator

Note!
Some of the Engineering tools mentioned offer alternative communication paths for
CAN. In this case, always select the "OPC" communication path.