Lenze EMF2180IB - Manual (Page 58)

9 Parameter reference
58
Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C0360
C0361
C1200
Address ranges
Parameter | Name:
C0360 | CAN frame counter
Data type: INTEGER_32
Index: 24215 = 0x5E97
All CAN frames of the CAN node that have been transmitted and received are counted.
The counters have 32 bits, i. e. when a value of 4294967295 is exceeded, the counting process starts again at 0.
Display range
(min. value | unit | max. value)
-2147483647 2147483647
Subcodes Info
C0360/1 Number of frames transmitted
C0360/2 Number of frames received
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C0361 | CAN bus load
Data type: INTEGER_32
Index: 24214 = 0x5E96
Using this code the percentage total bus load can be determined. Erroneous messages are not taken into account
here.
Note:
• The bus load for all devices involved should not exceed 80 %.
• If other devices, e. g. decentralised inputs and outputs are connected, these messages are also to be taken into
account.
Display range (min. value | unit | max. value)
0 % 100
 Read access  Write access  CINH  PLC-STOP  No transfer
Parameter | Name:
C1200 | Parameter data channel
Data type: INTEGER_32
Index: 23375 = 0x5B4F
This code indicates which of the two parameter data channels is used to communicate with other nodes. The
unused parameter data channels can be switched off, if required.
All Lenze inverters are provided with two parameter data channels featuring different addresses. The address of
parameter data channel 2 is calculated as follows:
Address of parameter data channel 2 = address of parameter data channel 1 + offset 64
Note:
The selection 0 means that the bus is operating in compliance with CANopen and there is no limitation on the
address space.
In this case, the parameter data channel SDO2 is inactive.
Selection list
(Lenze setting printed in bold)
0 CANopen
1 1
2 2
 Read access  Write access  CINH  PLC STOP  No transfer
Selection Accessible address range Active parameter data channels
0 1...127 SDO 1
1 1 ... 63 SDO 1 / SDO 2
2 65 ... 127 SDO 1 / SDO 2