Lenze EMF2180IB - Manual (Page 44)

6 Commissioning
6.3 Before initial switch-on
44
Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3 Before initial switch-on
Automatic address allocation and detection of the baud rate
The EMF2180IB communication module is provided with the following functions:
• Automatic address assignment
• Automatic detection of the baud rate
These functions are used to prevent failures due to an incorrectly set node address and baud rate.

Stop!
Before switching on the mains voltage, check ...
• the entire wiring for completeness, short circuit and earth fault:
• whether the bus system is terminated by means of a bus terminating resistor at the
first and last physical bus station.
 Connecting the CAN bus ( 21)

Note!
In the Lenze standard setting, these functions are not activated.
For this, observe the information relating to codes ...
• C0350 (CAN node address)
• C0351 (CAN baud rate)