Lenze EMF2180IB - Manual (Page 62)

9 Parameter reference
62
Lenze · EMF2180IB communication module (EthernetCAN) · Communication Manual · DMS 5.0 EN · 07/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C1216
C1217
C1219
Parameter | Name:
C1216 | User-specific device name
Data type: VISIBLE_STRING
Index: 23359 = 0x5B3F
The device name can be defined with maximally 25 characters by the user.
The following characters can be used for creating or changing the name:
• Letters: A ... Z, a ... z
• Numbers: 0 ... 9
• Special characters: "." and "-"
Characters deviating from this are replaced by a point.
The device name can also be entered on the gateway configuration web page.
Notes:
• The device name is saved in the communication module with mains failure protection.
• The automatic transfer of the device name to a DNS server does not take place.
• By loading the Lenze standard setting (via code C0002 ), the device name is neither reset nor changed.
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C1217 | Cycle time for CAN device monitoring
Data type: UNSIGNED_32
Index: 23358 = 0x5B3E
This code serves to set the cycle time for CAN device monitoring ( C1220 ).
The cycle time can also be set via the gateway configuration web page.
Setting range
(min. value | unit | max. value)
Lenze setting
1000 MS 30000 5000 ms
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C1219 | Activation of CAN device monitoring
Data type: UNSIGNED_32
Index: 23356 = 0x5B3C
The activated device monitoring enables the detection of bus nodes with disturbed bus communication.
The device monitoring function can also be activated via code C1220/0 or the gateway configuration web page.
Selection list
(Lenze setting printed in bold)
0 Not activated
1 activated
 Read access  Write access  CINH  PLC STOP  No transfer