Lenze IMSS500+ Simple Servo 500 600 i1000 - Manual (Page 11)

SimpleServo 500/600/i1000 User Manual Rev 3.4
Variables
Internal
format 64 bit
Number of User Variables 64
Variables resolution 64 bit
System variables resolution 64 bit
Arithmetic and logic functions
Arithmetic functions
Addition, Subtraction, Multiplication, Division
Logic and bitwise functions AND, OR, XOR, NOT
2.7 Connections and I/O
All models
RS232 serial interface Standard 9-pin D-shell (DCE)
Encoder Feedback Standard 15-pin D-shell
Encoder buffered repeat in 25-pin D-shell
Power 8-pin removable terminal block (9-pin for 3-P models)
SS500/600 drives
Digital Inputs
1 dedicated (ENABLE), 1 programmable.
Digital Outputs 1 dedicated (READY) , 1 programmable.
Analog Inputs 1 differential analog input. Full range +/- 10V single ended
and +/- 5V differential .Analog input is used for Torque or Velocity reference.
Analog Outputs 1 single ended analog output. +/- 10 V full scale range. Analog output can
be assigned to various drive’s signals.
I/O Controller 15-pin removable terminal block or 25-pin D-shell
Standard 25-pin D-shell
SSi10XX drives
Digital Inputs
5-24V rated 12 digital optically isolated inputs separated into 4 groups.
Each group has common terminal for the group. 2 of 12 inputs are suitable
for connection of master encoder with up to 2 MHz signals’ rate.
Digital Outputs 4 +1 dedicated optically isolated digital outputs. 20mA capability suitable for
24V system control voltages. Both collector and emitter available for each
output at the terminal.
Dedicated output assigned for “READY” function.
Analog Inputs 1 differential analog input. Full range +/- 10V single ended and +/- 5V
differential. Analog Input can be read via System Variable “AIN”.
Analog Outputs 1 single ended analog output. +/- 10 V full scale range. Analog output can
be set by User Program (System Variable AOUT) or via Host Interface.
I/O Connections 25-pin D-shell for digital I/O and 15-pin removable terminal block for analog
input/output connections.
Interfaces
RS-485
4-pin removable terminal block
Ethernet 10/100 RJ-45 modular jack (if equipped)
Windows® Software: MotionViewTM (Windows 95, 98, NT,2000)
11