Lenze IMSS500+ Simple Servo 500 600 i1000 - Manual (Page 37)

SimpleServo 500/600/i1000 User Manual Rev 3.4
DIP-SWITCH DS501 has its first 5 switches for address assignment and switch #6 for baud rate
selection. Two speeds are possible: 38,400 and 115,200 baud. As mentioned previously, up to 32
drives can be connected to a single network. Each drive on the network has to have its own unique
address set via DIP-SWITCH. Pulling switch UP sets it ON and pulling switch DOWN sets it OFF. The
drive address will be a sum of all ON switch values. For example, if switches 1,2, and 5 are ON and
the rest of the switches are OFF, the resulting address will be 1(#1)+2(#2)+16(#5) = 19.
TABLE 12 DIP-SWITCH DS501
Dip-switch # Value
1 1
2 2
3 4
4 8
5 16
6
OFF = 115200, ON = 38400 baud
To assign an address of 10, the sum of the switch values must be equivalent to 10. In this case,
switches 2 and 4 would need to be set to ON (2 + 8 =10).
Diagnostic LED. (green)
There are two LEDs near RS485 connector. Green LED lights up when data is sent to or from drive
over the RS485 interface. Refer to Section 9.1.2 for more information on the LEDs.
5.6.3 Ethernet interface.
SSi drives support standard 10/100 Ethernet connection via modular RJ-45 jack and CAT-5 standard
twisted pair network cable used in computer equipment. The RJ-45 socket has two integrated LEDs
showing network status. Green LED lights up when physical connection is present and yellow LED
lights up when SSi sends or receives data over the Ethernet.
SSi drives support both manual and automatic IP parameters assignment. Automatic (DHCP)
assignment of IP properties is possible if there is a DHCP server on the network. This is the default
setting. You can quickly connect drive(s) to floor/corporate network and configure it for further
operation. In manual mode you need to supply the IP address, Subnet mask, and Default gateway.
Default gateway address is needed only if drives are located on different subnets. If drives are on the
same network and there is no gateway supply to this field address of the host computer or address on
the same subnet but not used by any of the devices.
37