Lenze IMSS500+ Simple Servo 500 600 i1000 - Manual (Page 6)

SimpleServo 500/600/i1000 User Manual Rev 3.4
Safety Warnings
• The symbol shown at left indicates an important safety consideration. Please read this
manual carefully before performing any of the procedures contained herein. Failure to follow
these instructions may result in equipment damage, fire, severe injury, or fatality.
• Have a qualified electrical maintenance technician install, adjust and service this equipment.
Follow the National Electrical Code and all other applicable electrical and safety codes,
including the provisions of the Occupational Safety and Health Act (OSHA), when installing
equipment.
• The symbol shown at left indicates additional information, shortcuts, or tips that do not affect
the safe operation of the drive.
• Reduce the chance of an electrical fire, shock, or explosion by proper grounding, over-
current protection, thermal protection, and enclosure. Follow sound maintenance procedures.
• It is possible for a drive to run at full speed as a result of a component failure. Please
ensure that a master switch has been placed in the AC line to stop the drive in an
emergency.
WARNING!
Hazard of electrical shock! Circuit potentials are at 115 VAC or 230 VAC above earth
ground. Avoid direct contact with the printed circuit board or with circuit elements to prevent
the risk of serious injury or fatality. Disconnect incoming power and wait 60 seconds before
servicing drive. Capacitors retain charge after power is removed.
6