Lenze IMSS500+ Simple Servo 500 600 i1000 - Manual (Page 16)

SimpleServo 500/600/i1000 User Manual Rev 3.4
4 Installation
WARNING!
• Hazard of electrical shock! Circuit potentials are at 115 VAC or 230 VAC above earth
ground. Avoid direct contact with the printed circuit board or with circuit elements to prevent
the risk of serious injury or fatality. Disconnect incoming power and wait 60 seconds before
servicing drive. Capacitors retain charge after power is removed.
• The SimpleServo must be mounted vertically for safe operation at the maximum current
rating.
• Printed circuit board components are sensitive to electrostatic fields. Avoid contact with the
printed circuit board directly. Hold the SimpleServo by the case only.
• Protect the control from dirt, filings, airborne particles, moisture, and accidental contact.
Provide sufficient room for access to the terminal block.
• Mount the control away from other heat sources. Operate within the specified ambient
operating temperature range. Additional cooling with an external fan may be recommended
in certain applications.
• Avoid excessive vibration to prevent intermittent connections
• DO NOT connect incoming power to the output motor terminals (U, V, W)! Severe damage
to the SimpleServo will result.
• Do not disconnect any of the motor leads from the SimpleServo unless power is removed or
the control is disabled. Opening any one motor lead may cause failure.
• The DIN-rail mounting tab is designed to bear only the weight of the SimpleServo and heat
sink. Make sure enough slack exists in the wire routing to ensure that the cables do not tug
or pull downward against the DIN-rail mounting tab.
16